The Danfoss MCD 3000 soft starter is an advanced electronic motor starting system. It performs four main functions:
- Start control.
- Stop control, including both soft stop (extended op time) and braking (reduced stop time).
- Electronic motor protection.
- Monitoring & system interface.
Danfoss models MCD 3007 – 3132 are IP21 (NEMA 1) rated and have a local control panel that includes start, stop & reset push buttons. They are suitable for wall mounting, or installation in a switchboard. Danfoss models MCD 3185 – 3800 have an IP20 rating and must be installed in a switchboard or other enclosure.
The Danfoss MCD 3000 series soft starters are complete and require no optional modules to add functionality. Automatic detection and calibration for supply voltage and frequency eliminates the need for special models.
Danfoss MCD 3000 series soft starters are available with two maximum voltage ratings:
- 200 VAC ~ 525 VAC
- 200 VAC ~ 690 VAC
The Danfoss MCD 3000 power circuit uses reverse parallel connected thyristors to provide full wave control on all three phases. The Danfoss MCD 3000 starter can be used with or, if local regulations permit, without a line contactor.
Danfoss MCD 3000 Soft Starter Part Numbers
- Danfoss MCD 3007
- Danfoss MCD 3015
- Danfoss MCD 3018
- Danfoss MCD 3022
- Danfoss MCD 3030
- Danfoss MCD 3037
- Danfoss MCD 3045
- Danfoss MCD 3055
- Danfoss MCD 3090
- Danfoss MCD 3110
- Danfoss MCD 3132
- Danfoss MCD 3185
- Danfoss MCD 3220
- Danfoss MCD 3300
- Danfoss MCD 3315
- Danfoss MCD 3400
- Danfoss MCD 3500
- Danfoss MCD 3600
- Danfoss MCD 3700
- Danfoss MCD 3800
More Information on Danfoss MCD 3000 Soft Starters
For specific information and pricing on Danfoss MCD 3000 Soft Starters, please use our contact form or contact us via phone (908-418-2311).
·